As your marking needs may change, UMS supply a wide range of spares and accessories to complement your electrochemical marking systems. As well as our standard spares and accessories, UMS can also provide you with bespoke accessories, should you require.
Below is a selection of some of our spares and accessories. Please contact us for any other part that you may require, or to discuss any bespoke requirements that you may have.
|
Bench Marker
The UMS SBF/LBF bench marker has been designed to make the marking of awkward curved components simpler. It works by holding the stencil, pad, and electrolyte within itself. The component can then be rolled over the stencil, as opposed to the stencil being wrapped around the component.
|  |
Coarse Cleaning Blocks
Cleaning blocks are available to smooth the surface of any components before marking. Available in coarse or fine.
|  |
Earth Plate
Earth plates are available to connect your earth lead to direct from your Metaletch machine. This gives you the advantage of using your Metaletch machine in an area where there may not necessarily be an appropriate earthing point. |
 |
Footswitch
For use with the ME3000S, ME3000T or ME3000P marking systems, a Footswitch allows you hands free control of your marking unit. By pressing the pedal, the charge is sent. Releasing the pedal stops the charge.
|  |
Replacement Grid Kit For SMV
Replacement Grid Kits are available for a variety of widths up to 60mm for a twin SMV.
|  |
Leads
Replacement Leads for your Metaletch machine are available in two different lengths, 1m and 2m.
|  |
Mesh Pads
Mesh Pads for the HM series hand markers are available for all sizes. Sold in packs of 10.
|  |
Replacement Felt Pads
Electrolyte soaking Felt Pads to replace used ones are available in a variety of sizes and thicknesses, ready made to fit, or in large sheets for custom sizing. |  |
Replacement Grid Kit For CMD
Replacement Grid Kits for the CMD Cartridge Marker are available for all sizes. Reservoir Assemblies are also sold. |  |
Terminal Rings
Terminal Rings, used with a variety of marking heads, are just one of the many smaller components that we stock to compliment our range of Metaletch marking systems and accessories.
|  |
